ClimateMaster DD Series Manuel de service télécharger pdf (Page 9)

climatemaster.com

THE SMART SOLUTION FOR ENERGY EFFICIENCY

Tranquility

30 (TT) Series

Rev.: 07/18/13

Field Conversion of Air Discharge

Water

Connection End

Return Air

Remove Screws

Water

Connection End

Return Air

Rotate

Move to Side

Side Discharge

Return Air

Water

Connection End

Discharge Air

Drain

Back Discharge

Replace Screws

Water

Connection End

Supply Duct

Return Air

Water

Connection End

Drain

Return Air

Discharge Air

Side Discharge

Back Discharge

Overview - Horizontal units can be ﬁ eld converted

between side (straight) and back (end) discharge using

the instructions below.

Note: It is not possible to ﬁ eld convert return air

between left or right return models due to the

necessity of refrigeration copper piping changes.

Preparation - It is best to ﬁ eld convert the unit on the

ground before hanging. If the unit is already hung it

should be taken down for the ﬁ eld conversion.

Side to Back Discharge Conversion

1. Place unit in well lit area. Remove the screws as shown

in Figure 4 to free top panel and discharge panel.

2. Lift out the access panel and set aside. Lift and rotate

the discharge panel to the other position as shown,

being careful with the blower wiring.

3. Check blower wire routing and connections for

tension or contact with sheet metal edges. Re-route if

necessary.

4. Check refrigerant tubing for contact with other

components.

5. Reinstall top panel and screws noting that the location

for some screws will have changed.

6. Manually spin the fan wheel to ensure that the wheel

is not rubbing or obstructed.

7. Replace access panels.

Back to Side Discharge Conversion - If the discharge is

changed from back to side, use above instruction noting

that illustrations will be reversed.

Left vs. Right Return - It is not possible to ﬁ eld convert

return air between left or right return models due to

the necessity of refrigeration copper piping changes.

However, the conversion process of side to back or

back to side discharge for either right or left return

conﬁ guration is the same. In some cases, it may be

possible to rotate the entire unit 180 degrees if the return

air connection needs to be on the opposite side. Note

that rotating the unit will move the piping to the

other end of the unit.

Figure 5: Right Return Side to Back

Figure 4: Left Return Side to Back

1 2 3 4 5 6 7 8 9 10 11 12 13 14 ... 55 56

Commentaires sur ces manuels

Pas de commentaire

ClimateMaster DD Series Manuel de service Page 9

Commentaires sur ces manuels

Produits connexes et manuels pour Pompes à chaleur ClimateMaster DD Series